NEEDS MORE INFO
Will a washer (69x81x99 cm) fit in a space?
washer· 27 in × 32 in × 3 ft 3 in
+2 ft 5.5 in (+43%)of clearance at tightest point
Item being fitted
washer27 in × 32 in × 3 ft 3 in
Space clearance
Space6 ft 4 in × 16 ft 6 in × 5 ft 9 in
Result
2 ft 5.5 in of clearance
▸ height axis · binding
Expert analysis
A washer measuring 27 in × 32 in × 39 in likely fits in a space, with about 2 ft 5.5 in to spare at the tightest point. The binding dimension is height: that is the axis where the washer runs out of room.
+2 ft 5.5 in clearance
· ON THE HEIGHT AXIS
Here’s what we found.
- The height axis runs out of room.
3 ft 3 in vs 5 ft 9 in
Clearance +2 ft 6 in (+43.3%) on the HEIGHT axis
| Axis-aligned check (before rotation) | ||||||
| WIDTH | 27 in | ≤ | 6 ft 4 in | +4 ft 1.5 in | (+64.6%) | |
| DEPTH | 32 in | ≤ | 16 ft 6 in | +13 ft 10.5 in | (+83.9%) | |
| HEIGHT | 3 ft 3 in | ≤ | 5 ft 9 in | +2 ft 6 in | (+43.3%) | |
How the door-passage check works
A door is a 2D opening — width and height matter; depth (path length through the doorway) doesn’t.
- Generate all 6 dimension permutations of the item (3 axes × 2 flips).
- For each permutation, apply the door constraint: item_width ≤ door_width AND item_height ≤ door_height.
- Subtract 1.5 in handling clearance from each axis to leave room for human movement.
- Pick the permutation with the largest minimum-axis margin — that’s the orientation a mover would choose.
- Verdict ladder (verdict-tiers.js): FITS if margin ≥ 2 in; FITS_TIGHT if 0.5–2 in; FITS_VERY_TIGHT if 0–0.5 in; DOESN'T_FIT below.
Tolerance ±¼ in (6 mm) is applied implicitly (band promotion to FITS_VERY_TIGHT) — see the note below the orientation matrix.
Dimensions
- item widthStandard size
- item depthStandard size
- item heightStandard size
- space widthEstimated
- space depthEstimated
- space heightEstimated
Space geometry
- Square corners and a flat floor
- No trim, fixtures, or hardware protruding into the opening
- Door swings fully open (90°+) and stays open during passage
Handling
- ±¼ in tape-measure tolerance applied
- 1.5 in handling clearance subtracted from raw margins before the verdict
- Item treated as rigid — cannot compress, bend, or disassemble.
Why we make assumptions
ItemFits fills in anything you don’t measure yourself. Whenever you see [standard], the real value in your home may differ — measure it and message us in the chat below; we’ll re-run the math.
Similar calculations
Run your own fit check
Ask about a different item, door, or route. Free, no signup.