Will a king size bed (193x203x25 cm) fit in a room?
Expert analysis
A king size bed measuring 76 in × 80 in × 10 in does not fit in a room, but it's about 5 ft 7 in too large at the tightest point. One caveat: item is rigid and cannot be compressed, bent, or disassembled.
- Binding axis
- Room short
- Tightest clearance
- 5 ft 7 in over
- Result
- Room short does not clear
It exceeds the opening at the tightest point.
Your king size bed will not fit in the room — and it is clearly over the limit at the tightest point.
Handling: The item exceeds the space in every orientation — standard entry won't work.
| Orientation | Min walkway | Strategy | Result |
|---|---|---|---|
| 0° (as-is), long wall | 0 mm | — | ✕ |
| 0° (as-is), short wall | 0 mm | — | ✕ |
| 90° rotated, long wall | 0 mm | — | ✕ |
| 90° rotated, short wall | 0 mm | — | ✕ |
| diagonal (1°–89°) | 0 mm | — | ✕ |
How the room-fit check works
A room is a 2D footprint — width and depth matter for placement, plus the walkway gap left between the item and walls or other obstacles.
- Place the item footprint inside the room rectangle in the orientation it will be used.
- Compute walkway gaps from each item edge to every wall and to other obstacles in the room.
- Take the minimum walkway gap — that’s the daily-traffic clearance the room must support.
- Verdict ladder (getRoomVerdictTier): walkway <18 in DOESN'T_FIT; 18–24 VERY_TIGHT; 24–36 TIGHT; 36–48 FITS; ≥48 confident FITS.
Walkway thresholds use standard ergonomic minimums; a confident mover may negotiate gaps tighter than the recommended tier.
Dimensions
- item widthStandard size
- item depthStandard size
- item heightStandard size
- space width
- space depth
- space heightEstimated
Space geometry
- Square corners and a flat floor
- Existing furniture footprints already factored out of the usable area
Handling
- ±¼ in tape-measure tolerance applied
- 1.5 in handling clearance subtracted from raw margins before the verdict
- Item treated as rigid — cannot compress, bend, or disassemble.
Other assumptions
- A bed is modeled as its mattress — the largest single rigid piece for moving. Frames and headboards detach and are measured separately, so the height shown is the mattress thickness, not the assembled bed.
Why we make assumptions
ItemFits fills in anything you don’t measure yourself. Whenever you see [standard], the real value in your home may differ — measure it and message us in the chat below; we’ll re-run the math.
Similar calculations
Run your own fit check
Ask about a different item, door, or route. Free, no signup.