FITS
It fitswith 0 in to spare
Will an accent chair (76x81x86 cm) fit in a space?
Accent Chair· 30 in × 32 in × 34 in
+0 in (+65%)of clearance at tightest point
Item being fitted
Accent Chair30 in × 32 in × 34 in
Space clearance
Space10 ft × 12 ft × 8 ft
Result
0 in of clearance
▸ height axis · binding
Expert analysis
A accent chair measuring 30 in × 32 in × 34 in fits in a space, with about 0 in to spare at the tightest point.
+5 ft 2 in clearance
· ON THE HEIGHT AXIS
It fits with clearance on every axis.
Your accent chair will fit, but only barely — there is almost no room for error.
34 in vs 8 ft
Clearance +5 ft 2 in (+64.6%) on the HEIGHT axis
| Axis-aligned check (before rotation) | ||||||
| WIDTH | 30 in | ≤ | 10 ft | +7 ft 6 in | (+75.0%) | |
| DEPTH | 32 in | ≤ | 12 ft | +9 ft 4 in | (+77.8%) | |
| HEIGHT | 34 in | ≤ | 8 ft | +5 ft 2 in | (+64.6%) | |
How the door-passage check works
A door is a 2D opening — width and height matter; depth (path length through the doorway) doesn’t.
- Generate all 6 dimension permutations of the item (3 axes × 2 flips).
- For each permutation, apply the door constraint: item_width ≤ door_width AND item_height ≤ door_height.
- Subtract 1.5 in handling clearance from each axis to leave room for human movement.
- Pick the permutation with the largest minimum-axis margin — that’s the orientation a mover would choose.
- Verdict ladder (verdict-tiers.js): FITS if margin ≥ 2 in; FITS_TIGHT if 0.5–2 in; FITS_VERY_TIGHT if 0–0.5 in; DOESN'T_FIT below.
Tolerance ±¼ in (6 mm) is applied implicitly (band promotion to FITS_VERY_TIGHT) — see the note below the orientation matrix.
Dimensions
No dimension-specific assumptions surfaced for this check.
Space geometry
- Square corners and a flat floor
- No trim, fixtures, or hardware protruding into the opening
- Door swings fully open (90°+) and stays open during passage
Handling
- ±¼ in tape-measure tolerance applied
- 1.5 in handling clearance subtracted from raw margins before the verdict
- Item treated as rigid — cannot compress, bend, or disassemble.
Why we make assumptions
ItemFits fills in anything you don’t measure yourself. Whenever you see [standard], the real value in your home may differ — measure it and message us in the chat below; we’ll re-run the math.
Similar calculations
Run your own fit check
Ask about a different item, door, or route. Free, no signup.