DOESN'T FIT
It doesn't fitby 3.5 in too large
Will a fridge (80x80x190 cm) fit in a space?
fridge· 31 in × 31 in × 6 ft 3 in
−3.5 in (−11%)too large at tightest point
Item being fitted
fridge31 in × 31 in × 6 ft 3 in
Space clearance
Space28 in × 6 ft 8 in
Result
3.5 in too large
▸ width axis · binding
Expert analysis
A fridge measuring 31 in × 31 in × 75 in does not fit in a space, but it's about 3.5 in too large at the tightest point. The binding dimension is width: that is the axis where the fridge runs out of room.
−3.5 in over
· ON THE WIDTH AXIS
It exceeds the opening at the tightest point.
- The width axis runs out of room.
31 in vs 28 in
Overage −3 in (−11.1%) on the WIDTH axis
| Axis-aligned check (before rotation) | ||||||
| WIDTH | 31 in | > | 28 in | −3 in | (−11.1%) | |
| DEPTH | not applicable | |||||
| HEIGHT | 6 ft 3 in | ≤ | 6 ft 8 in | +5 in | (+6.5%) | |
How the door-passage check works
A door is a 2D opening — width and height matter; depth (path length through the doorway) doesn’t.
- Generate all 6 dimension permutations of the item (3 axes × 2 flips).
- For each permutation, apply the door constraint: item_width ≤ door_width AND item_height ≤ door_height.
- Subtract 1.5 in handling clearance from each axis to leave room for human movement.
- Pick the permutation with the largest minimum-axis margin — that’s the orientation a mover would choose.
- Verdict ladder (verdict-tiers.js): FITS if margin ≥ 2 in; FITS_TIGHT if 0.5–2 in; FITS_VERY_TIGHT if 0–0.5 in; DOESN'T_FIT below.
Tolerance ±¼ in (6 mm) is applied implicitly (band promotion to FITS_VERY_TIGHT) — see the note below the orientation matrix.
Dimensions
- item width
- item depth
- item height
- space width
- space depth
- space heightEstimated
Space geometry
- Square corners and a flat floor
- No trim, fixtures, or hardware protruding into the opening
- Door swings fully open (90°+) and stays open during passage
Handling
- ±¼ in tape-measure tolerance applied
- 1.5 in handling clearance subtracted from raw margins before the verdict
- Item treated as rigid — cannot compress, bend, or disassemble.
Why we make assumptions
ItemFits fills in anything you don’t measure yourself. Whenever you see [standard], the real value in your home may differ — measure it and message us in the chat below; we’ll re-run the math.
Similar calculations
Run your own fit check
Ask about a different item, door, or route. Free, no signup.