Will a cabinet (70x40x26 cm) fit in a space?
Expert analysis
A cabinet measuring 28 in × 16 in × 10 in fits in a space, with about 2 ft 3.5 in to spare at the tightest point. That margin already subtracts a 1 in handling allowance, so it reflects a realistic load rather than a paper-thin theoretical fit. One caveat: item is rigid and cannot be compressed, bent, or disassembled.
- Binding axis
- Hallway width
- Tightest clearance
- 2 ft 3.5 in clear
- Orientations checked
- 6
- Result
- Every axis clears
It fits with clearance on every axis.
Your cabinet will fit through the hallway, with comfortable room to spare.
Handling: Slide the item straight through the opening in its narrowest orientation.
| Orientation | Width | Height | Result |
|---|---|---|---|
| ✓ chosen— | 26 cm | 2.2 m | ✓ |
| — | 26 cm | 2.0 m | ✓ |
| — | 70 cm | 1.7 m | ✓ |
| — | 70 cm | 2.0 m | ✓ |
| — | 56 cm | 1.7 m | ✓ |
| — | 56 cm | 2.2 m | ✓ |
Margins shown are calculated; allow ±¼ in for tape-measure precision.
How the door-passage check works
A door is a 2D opening — width and height matter; depth (path length through the doorway) doesn’t.
- Generate all 6 dimension permutations of the item (3 axes × 2 flips).
- For each permutation, apply the door constraint: item_width ≤ door_width AND item_height ≤ door_height.
- Subtract 1.5 in handling clearance from each axis to leave room for human movement.
- Pick the permutation with the largest minimum-axis margin — that’s the orientation a mover would choose.
- Verdict ladder (verdict-tiers.js): FITS if margin ≥ 2 in; FITS_TIGHT if 0.5–2 in; FITS_VERY_TIGHT if 0–0.5 in; DOESN'T_FIT below.
Tolerance ±¼ in (6 mm) is applied implicitly (band promotion to FITS_VERY_TIGHT) — see the note below the orientation matrix.
Dimensions
- item width
- item depth
- item height
- space width
- space depth
- space heightEstimated
Space geometry
- Square corners and a flat floor
- No trim, fixtures, or hardware protruding into the opening
- Door swings fully open (90°+) and stays open during passage
Handling
- ±¼ in tape-measure tolerance applied
- 1.5 in handling clearance subtracted from raw margins before the verdict
- Item treated as rigid — cannot compress, bend, or disassemble.
Why we make assumptions
ItemFits fills in anything you don’t measure yourself. Whenever you see [standard], the real value in your home may differ — measure it and message us in the chat below; we’ll re-run the math.
Similar calculations
Run your own fit check
Ask about a different item, door, or route. Free, no signup.