Size reference
Standard pool table dimensions.
Regulation playing surfaces: 7 ft = 78 × 39 in, 8 ft = 88 × 44 in, 9 ft = 100 × 50 in (all 2:1). Add ~12–14 in to each dimension for the outer cabinet. A 9 ft table's outer cabinet is about 114 × 64 in. Slate bed is ~1 in thick, usually in 3 pieces.
Run a check
Will it fit?
On moving day
Moving tips.
- 01Never move a slate pool table fully assembled — disassemble the rails, felt, and slate first.
- 02Each slate piece is heavy and fragile; carry it flat, edge-up, with two or more people and proper straps.
- 03Confirm the floor can carry 700–1,000 lb in one spot, especially on upper floors.
- 04Have the table re-leveled and the felt re-stretched after reassembly — this is a job for a professional installer.
Measure smart
What to measure.
Four numbers decide nearly every fit check. Get these right and the rest follows.
- 01Your pool table's width, height, and depth at their widest points — including handles, feet, and any fixed trim. A standard pool table runs about 100" wide, but compact and oversized versions vary by several inches, so measure yours rather than trusting the label.
- 02The smallest face of the pool table and its diagonal. Many pieces only clear a tight opening when tilted, and that turns on the diagonal, not the flat width.
- 03Every opening on the route, not just the destination room — the door, the hallway and any turn, the stair width, and the elevator. "Through a Door" is the check people run most for a pool table, but the tightest point on the whole path is what decides the move.
- 04The pool table's weight, especially for solid-wood pieces, so you know how many people and what equipment the move needs.
Don't make these
Common mistakes.
Most “it didn't fit” stories trace back to one of these oversights.
- ⚠Measuring the room the pool table is headed for but forgetting the doorway, hallway turn, or stair landing it has to pass through first.
- ⚠Ignoring the diagonal. A pool table that looks too wide for a door often clears it tilted — but only if you measured the diagonal, not the flat face.
- ⚠Leaving legs, doors, drawers, or cushions on. Removing them often saves the few inches that decide the fit for a pool table.
- ⚠Assuming a published size matches your exact pool table. Apartment, compact, and oversized models differ by several inches.
Frequently asked
Questions we keep getting.
What size is a regulation pool table?
Regulation tables come in three sizes by playing surface: 7 ft (78 × 39 in), 8 ft (88 × 44 in), and 9 ft (100 × 50 in). All hold a 2:1 length-to-width ratio. The named size refers to the playing surface, not the wooden cabinet.
01How much bigger is the cabinet than the playing surface?
Add about 12–14 in (30–36 cm) to each playing-surface dimension for the rails and cabinet. So a 9 ft table's outer cabinet is roughly 114 × 64 in (290 × 163 cm) — plan the room around the cabinet, then add 5 ft of cue clearance on every side.
02How much does a pool table weigh?
A 7 ft table is about 700 lb, an 8 ft about 850 lb, and a 9 ft about 1,000 lb. The slate alone is 400–600 lb on a 9-footer, which is why floor load capacity matters more than doorway width.
03Do you move a pool table in one piece?
No. A quality table uses 1 in slate shipped in three pieces, and the whole table is assembled in the room. The fit question is getting the heaviest single slate piece (~130–200 lb) down stairs and around corners — not through a door whole.
04